...
| Table of Contents | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Delivery condition and prerequisits 📦
Thank you for choosing Jellox. You will find the scope of delivery in your packaging according to your order. You can check the completeness of the order against the delivery slip.The following scope of delivery is available for Jellox:
...
| Note |
|---|
Jellox requires server version 52v007 or higher. Please contact Microtronics Support if your myDatanet server does not meet this requirement. |
Set Jellox to operating mode 🛠️
First, the antenna is mounted on the connector provided.
...
Connect the analogue sensor of your choice using the 7-pin connection cable.
Trigger connection 📡
| Info |
|---|
Jellox is delivered in the operating mode “transport”. |
...
| Info |
|---|
The measurement data displayed is based on the default settngs of the sensors. These settings can be configured in the site itself. |
Create a site 💻
| Info |
|---|
A credit balance on the server is required for the creation of a site. More detailed information can be found here: Server credit management. |
...
| Info |
|---|
The number of steps in the wizard is based on your current server configuration. Steps (4) & (5) may therefore be displayed differently. |
Activate analogue input 🔧
The configurations of the site are synchronised with the measurement device with each connection. The behaviour of the measurement device is set with the site configuration.
...
| Note |
|---|
After saving, a new connection must be triggered using the magnet in order to transmit the setting to the Jellox. |
Obtain first measurement data 📊
| Note |
|---|
Before the measurement data appears on the server, please wait 2-3 minutes for the first measurements to be carried out. In addition, a new connection must be initiated using the magnet. |
...
| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
Congratulations!! |
Adjust additional settings🔧
tba
...
Feedback 
| Info |
|---|
our feedback is needed! Please let us know how we can improve our commissioning process! |
...