Quickstart - Jellox Analog EN
- Marcel Ortler
- Stefanie Buber
For the English version click the following link: Quickstart - Jellox Analogue EN
1. Delivery condition and prerequisits
Thank you for choosing Jellox.
a. You can check the order against the delivery slip to ensure it is complete.
b. Unpack the radar sensor and position it so that the radar antenna points towards the ceiling.
1 Radar antenna |
|
2. Connecting Jellox
1 Antenna connector | 2 Analogue sensor connector |
Haben Sie noch Fragen zu diesem Schritt? Eine Sammlung von Antworten finden Sie hier.
3. Commissioning Jellox
Tap the supplied magnet for at least 3 seconds on the indicated position to set the Jellox to operating mode “normal”. When establishing the connection, the aircraft symbol is replaced by a rotating arrow symbol.
Once the connection is complete, the symbol with rotating arrows disappears again. If the display switches off in the meantime, it can be reactivated with the magnet. To do so, briefly tap the magnet on the position indicated in the video.
1 Information about the network connection | |
Field strength of the mobile network signal during the last connection | |
| Transport mode activated |
2 Status of the mobile network connection | |
| mobile connection disconnected; wait for next connection establishment |
(blinking) | connecting |
| connection to the myDatanet server established |
| last connection failed |
Do you still have questions about this step? You can find a pool of answers here.
4. Creating a site
a. Log on to the Server.
You will receive the login details and the credit for the server from your responsible sales partner.
b. Open the wizard.
|
The serial number can be found on the type plate at the rear of the Jellox and on the packaging.
c. Create the site.
1 Activate the checkbox to switch directly to the input mask for configuring the site. |
2 Create site |
Do you still have questions about this step? You can find a pool of answers here.
5. Activate and configure analogue input
a. Select the Select the appropriate mode for your analogue sensor
1 Selection of mode |
|
|
b. Configure the limits
1 Lower limit analogue sensor | 2 Upper limit analogue sensor | 3 Unit of the analogue sensor |
c. Switch to the tab “Configuration“ (3) and set warmup time and voltage.
1 Select warmup time | 2 Select voltage | 3 “Configuration” tab |
d. Save your settings
1 Save your settings |
|
|
e. Trigger a connection to transmit the settings to the device.
Do you still have questions about this step? You can find a pool of answers here.
6. View first measurement data
1 View measurement data |
|
1 Measurement data analogue sensor | 2 Measurement data first remote sensor |
Do you still have questions about this step? You can find a pool of answers here.
Make further adjustments
FAQs